Maximum Mystic (pre-2001) Bedienungsanleitung PDF herunterladen

MYSTIC

INSTALLATION

PROPER INSTALLATION IS IMPORTANT. IF YOU NEED ASSISTANCE, CONSULT A CONTRACTOR, ELECTRICIAN

OR TELEVISION ANTENNA INSTALLER (CHECK WITH YOUR LOCAL BUILDING SUPPLY, OR HARDWARE STORE

FOR REFERRALS). TO PROMOTE CONFIDENCE, PERFORM A TRIAL WIRING BEFORE INSTALLATION.

Samuel Barnett Boulevard

New Bedford, MA 02745

(508) 995-2200

Connect the AC adapter to Mystic and plug into outlet. The display will

briefly light up all the indicator lights (self test) and then will show the

barometer function light and the center display will show a pressure

reading. Leave the instrument in this mode for two hours. Do not

activate the switch at the bottom of the case in any way. At the end

of the two hour wait Mystic will be ready to have the pressure adjustment

performed. The temperature sensor can be installed during this wait.

Form a drip loop with the wire at least eight inches

below the exit from the sensor and at least eight inches

below the point of entry into the building. Anchor any

exposed wire with insulated cable clips. Run the wire

through the building to the location where the indicator

will be located. Caulk any holes when done.

Unplug the AC adaptor and disconnect the wires. Mystic is now ready for the final installation.

The adjustment that you have made will always remain intact.

If two hours has elapsed since Mystic was plugged in, the barometer can

now be calibrated for your location. Obtain the current barometric pressure

for your area by calling a near-by airport or an individual who has a properly set

barometer. Insert a small screw driver into the recessed slotted screw at the back

of Mystic. Turn the screw while observing the pressure read out on the front of

Mystic. Due to the sensitivity of this adjustment, the numbers on the display

may fluctuate during this procedure. It may take a minute to achieve the exact

setting.

Mount the temperature sensor assembly with the two

large wood screws. Select a location that is protected

from direct sunlight and sheltered from rain and physical

damage. (A north exposure, six feet above the ground

will give the best results.)

DRIP

LOOP

CAULK

CABLE

CLIP

MIN

1 2 3 4 5

Inhaltsverzeichnis

Seite 1 - INSTALLATION

MYSTICINSTALLATIONPROPER INSTALLATION IS IMPORTANT. IF YOU NEED ASSISTANCE, CONSULT A CONTRACTOR, ELECTRICIAN OR TELEVISION ANTENNA INSTALLER (CHEC

Seite 2 - INSTALLATION (CONT.)

MYSTICINSTALLATION (CONT.)Samuel Barnett BoulevardNew Bedford, MA 02745(508) 995-2200Feed the cables from the AC adapter and the temperature sensor th

Seite 3 - OPERATION

MYSTICOPERATIONSamuel Barnett BoulevardNew Bedford, MA 02745(508) 995-2200NOTE: After any "FULL" reset, temperature and or wind chill data w

Seite 4 - (508) 995-2200

MYSTICIMPORTANT FACTS ABOUT YOUR MYSTICSamuel Barnett BoulevardNew Bedford, MA 02745(508) 995-2200Latch Up- Power Line disturbances, improper powering

Seite 5

IMPORTANT ADDITIONAL INFORMATION Components: Along with the indicator, the following components are included with this instrument:

Kommentare zu diesen Handbüchern

Keine Kommentare

Maximum Mystic (pre-2001) Bedienungsanleitung

Stöbern Sie online oder laden Sie Bedienungsanleitung nach Messgeräte Maximum Mystic (pre-2001) herunter. Maximum Mystic (pre-2001) User Manual [es] Benutzerhandbuch

Inhaltsverzeichnis

Kommentare zu diesen Handbüchern

Verwandte Produkte und Handbücher für Messgeräte Maximum Mystic (pre-2001)